Roofing Company in Smithville, TX

Smithville replacements are often on homes that have been re-covered more than once. We take everything off, replace the decking that has gone soft under old layers, reflash the chimneys, and put on a roof that suits the house, shingles or standing seam. On the newer homes along Highway 71 it is a standard replacement to spec.

Shingle roofing in Smithville is often a re-roof on a historic home with original decking, or a replacement on a 1990s house on the edge of town. Either gets synthetic underlayment, proper flashing, ventilation, and a Class A rated shingle.

Metal is most of what we do in Smithville: replacing tired exposed-fastener roofs on homes and barns, converting old tin to standing seam, and roofing new shops with R-panel. We can usually do the house and the outbuildings on one trip.

New construction around Smithville is custom homes and barndominiums on acreage, shops and barns. We do dry-in and finish in metal or shingle and coordinate with the builder or the owner-builder.

Free inspections in Smithville are useful before buying an older home, where the roof age is often unknown. We look at the decking from the attic, check every flashing, and give you photos and an honest remaining-life estimate.

The typical Smithville repair is a leak on an older roof: a rusted valley, a chimney with no proper counter-flashing, or a section of metal with screws backed out. We repair what will hold and are honest when a roof has more patches than roof left.

Smithville leaks show up on old roofs under old trees: a valley full of debris, a chimney flashing that has separated, a tin roof with a rusted fastener. We trace the leak from the attic, repair the entry point, and tell you honestly how much life the roof has left.

Wind and falling limbs do more damage in Smithville than hail, though hail comes through too. We tarp active leaks, document the damage for your carrier, and repair or replace to the approved scope.

Wind damage in Smithville is limbs on old roofs and laps lifting on old tin. We secure what is open, replace what is broken, and are honest about how much life the roof has.

Smithville emergencies are usually a limb through an old roof on a shaded lot, or a wind front lifting panels on tired metal. We secure the opening, stop the water, photograph it for your carrier, and do the permanent repair once it is dry.

Smithville is at the edge of the hail corridor, and most claims here are wind and tree damage. We document what happened, separate it from age on the older roofs, meet the adjuster, and do the work to the approved scope.

Flat and low-slope roofs for shops, offices, retail and warehouses.

• TPO and single-ply membrane installation and replacement
• Flat roof repair: seams, drains, curbs, penetrations and ponding areas
• Metal roof retrofit for commercial and ag buildings
• Modified bitumen and built-up roof repair

Single-ply membrane for flat and low-slope roofs, commercial and residential.

• New TPO installation on flat and low-slope roofs
• TPO replacement, including wet insulation removal
• TPO repair: seams, flashings, drains and punctures
• Low-slope sections on homes: porches, additions and flat roofs

Seams, drains, ponding and flashings on low-slope roofs, homes and small commercial.

• TPO, modified bitumen, EPDM and built-up roof repair
• Seam repair and rewelding
• Drain, scupper and gutter flashing repair
• Ponding area correction

Commercial metal roofing in Smithville is the shops, barns and small industrial buildings around town: fastener replacement, panel replacement and new R-panel or standing seam roofs.

A written condition report with cores, photos and options, per building.

• Roof walk with photo mapping of every defect
• Core samples for wet insulation, patched afterward
• Drain, scupper and gutter check
• Seam, flashing, curb and parapet condition